Cover Base Coats | 2+1

• The rubber in the base perfectly levels the nail surface, filling in all scratches and fine cracks.
• Does not run onto the cuticles.
• Nails covered with this base are strengthened and retain their flexibility, reducing the likelihood of nail breakage.
• The base is perfectly suited to weak, thin, peeling nails.
• With this base you can minimally extend the nail plate and restore a split nail.
• "RB Cover Base" bases have a camouflage shade that hides natural nail imperfections and gives a soft, natural colour.
• These bases are perfectly suited for creating French and Ombre designs.
• Features a thick consistency. 

• The glass fibre (FiberGlass) in the FIBER base helps protect weak, break-prone nails.
• Levels the nail surface, filling in all scratches and fine cracks.
• Contains vitamin E and calcium.
• Prevents further damage to the nail plate;
• nails covered with this base are strengthened and retain their flexibility;
• the base has a milky shade that hides natural nail imperfections and gives a soft colour;
• does not run onto the cuticles, self-levelling.  

1. Clean, disinfect, push back the cuticles and remove oils with the nail dehydrator PREP.
2. Lightly prime the nail tips with PRIMER or ULTRABOND. Avoid contact with skin, let dry for 30 seconds. Recommendation: apply sparingly to the nail tips.
3. Apply the chosen base to the nails and cure under the lamp*. Apply to the thumbs and cure under the lamp*. Recommendation: when applying the base, do not over-apply.
4. Apply a thin layer of your chosen polish and cure under the lamp*. Apply a second layer and cure again under the lamp*. Recommendation: pay attention to the nail edges so that a thick layer of polish does not form on the nail tips; this way the gel polish will last longer.
5. Apply a thin, smooth layer of "Crystal Top Coat" to protect the colour. Cure under the lamp*.
6. When using a sticky top coat, remove the tacky layer with the nail cleanser "UV Gel Cleanser".

*Curing time depends on lamp power (e.g. in a 48W lamp the gel polish sets in just 15 seconds).

1. Remove the top layer of polish with a nail file. Recommendation: push back the cuticles before using the file so the top layer comes off more easily.
2. Fully soak a wipe with the gel polish remover. Place on the whole nail surface and wrap fingers in foil so the product does not evaporate and heat stays inside.
3. Leave for 10 minutes, then check the condition. Some shades may need more time. If needed, soak for another 5 minutes.
4. Remove the foil from the fingers and gently wipe off the polish with a cuticle pusher or a wooden tool. Recommendation: do not use force when removing polish. Residue can easily be buffed off.