Pigment Powder "Crystal Yellow"

1. Cleanse, disinfect, push back the cuticles and remove oils with the PREP nail dehydrator.
2. Lightly apply PRIMER or ULTRABOND to the nail tips. Avoid contact with the skin and let dry for 30 seconds. Tip: apply sparingly to the nail tips.
3. Apply a thin layer of clear “Base Coat” or the rubber, camouflage base “RB Base Coat” to the nails and cure under the lamp. Apply to the thumbs and cure under the lamp. Tip: do not overfile when applying the base.
4. Apply a thin layer of your chosen polish and cure under the lamp. Apply a second layer and cure again. Tip: pay attention to the nail edges so that a thick polish layer does not form on the nail tips; this helps gel polish last longer.
5. Remove the sticky (dispersion) layer with the “UV Gel Cleanser”.

1. Draw the desired lines with white gel polish or “Ultra White” gel.
2. Select a pigment and sprinkle it over the design, then cure under the lamp.
3. Brush off the excess dust with a brush.
4. Apply a thin, smooth layer of “Crystal Top Coat” to protect the colour. Cure under the lamp.

1. Apply black gel polish to the nails and cure in the lamp.
2. Apply the “Picasso” pouring base, then form smoke, clouds or patterns with white gel polish and cure in the lamp.
3. Select a pigment and sprinkle it onto the nail, then cure under the lamp.
4. Brush off the excess dust with a brush.
5. Apply a thin, smooth layer of “Crystal Top Coat” to protect the colour. Cure under the lamp.

1. Prepare a white design using one of the methods described above, then cure in the lamp.
2. Remove the sticky (dispersion) layer with the “UV Gel Cleanser”.
3. Select the pigments and rub them in where needed.
4. Apply a thin, smooth layer of “Crystal Top Coat” to protect the colour. Cure under the lamp.

*Curing time depends on lamp power (e.g. in a 48W lamp the gel polish sets in as little as 15 seconds).